Industries

Radiopharmacy and nuclear medicine facilities

Radiopharmacy combines two sets of requirements that pull against each other. GMP wants a clean, smooth, easily decontaminated room. Radiation safety wants mass, shielding and containment. The building has to satisfy both at once.

Home › Controlled environments › Radiopharmacy and nuclear medicine

Why this sector needs a different builder

A PET radiopharmaceutical has a working life measured in hours. It cannot be made somewhere else and shipped. That single fact drives everything about these facilities: they get built near the patients, they run to a clock, and when the production suite is down the service stops.

It also means the facility carries obligations that most builders never meet. GMP for the product. Radiation safety regulation for the isotopes, administered by your state health regulator. Structural engineering for shielding masses that are unlike anything in an ordinary commercial building. And building approval from a certifier who has probably not seen one before.

The constraints that shape the building

Shielding is structure

A cyclotron vault is not a room with thick walls. It is a structural problem where the walls are the structure, the mass is measured in hundreds of tonnes, and the foundation design follows from the shielding calculation rather than the other way around. The shielding design comes from a qualified expert, and the building is then engineered around their numbers.

The equipment arrives before the building is finished

Cyclotrons, hot cells and shielded transfer systems are large, extremely heavy, and often delivered in single pieces that will not fit through any door you would normally build. The delivery route, the crane position, the temporary opening and the sequence of who is on site when are design decisions, not site decisions.

On a facility with a multi tonne cyclotron, the question "how does it get in" has to be answered on the drawings. Finding out after the roof is on is the most expensive discovery available in this sector.

Two clean standards in one room

Dispensing and aseptic work need a classified clean environment with a pressure regime that protects the product. Radiation containment often wants air moving the other way. Reconciling those is a mechanical design exercise with real consequences for the room fabric, and it has to be settled before the panel system is ordered.

Services through shielding

Every penetration through a shielded wall is a potential radiation path, so services routes have to be planned with the shielding expert rather than coordinated around them afterwards.

Decommissioning is a design input

Activated structures and contaminated surfaces have an end of life. Facilities that were designed with that in mind cost less to deal with later.

What we bring

We are a licensed builder with GMP cleanroom delivery behind us, and we have done the engineering and cost work to understand what a modern cyclotron and vault impose on a building: the mass, the wall thicknesses, the foundation implications, the delivery and installation sequence, and the way the GMP suite has to be arranged around all of it.

That is a small field in Australia. Most cleanroom specialists cannot take the structure. Most builders who can take the structure have never built to GMP. Very few have done the work to understand what sits between them.

We would rather be in the conversation while the shielding expert, the equipment vendor and the architect are still settling the layout, because that is when a builder can still save you money.