Technical note

What an auditor looks at in a controlled environment

Regulators, certification bodies and customer auditors are looking at different rule books, but when they walk a controlled environment they look at a remarkably similar list of physical things. Most of that list is construction.

Home › Technical notes › What an auditor looks at

They follow the flows

The first thing an experienced auditor does is walk the path a person takes into the room, and the path the product and the waste take. They are looking for crossings that should not happen, shortcuts the layout makes possible, and steps that can be skipped without anyone noticing.

This is a floor plan issue. It cannot be fixed with a procedure, and it is very expensive to fix once the walls are up.

They look at junctions, not surfaces

Nobody fails an inspection because a wall panel was the wrong colour. They fail on the places where two things meet.

  • Wall to floor junctions, and whether the coving is intact and cleanable
  • Wall to ceiling junctions
  • Penetrations for services, and what they were sealed with
  • Around door frames, and whether the seal is continuous
  • Around fixed equipment where it meets the room fabric
  • Anywhere a sealant has cracked, shrunk, discoloured or been repaired badly

A junction that cannot be cleaned is a finding, whatever the material either side of it is. Junctions are the builder's responsibility and they are where the marks are lost.

They check the pressure regime is real

Gauges are read, doors are opened, and the question is whether the cascade holds in practice rather than on the design drawing. A room that cannot hold its differential when a door opens, or where the gauge has been ignored for months, invites a much closer look at everything else.

They look up

Ceilings, ceiling voids and overhead services. Whether the void is sealed from the room. Whether there is condensation on anything above exposed product. Whether light fittings are flush and sealed. Whether anything above the room can shed onto it.

They look at what has been changed since it was built

This is where facilities most often come undone. A shelf screwed to a wall. A cable run added through a panel. A new piece of equipment with a penetration cut for its services. A door propped open because the flow does not work.

Each one was a small, sensible decision. Collectively they are the difference between a facility that was built compliant and a facility that is compliant.

They ask for the evidence

Finish certification. Commissioning records. Filter certificates. As built drawings that match what is behind the wall. If the construction evidence is missing, the physical inspection gets harder, because nothing can be taken on trust.

What this means when you are choosing a builder

Ask them what they seal penetrations with and why. Ask how they detail a wall to floor junction. Ask what documentation they hand over and when. Ask whether they have been on site during an inspection.

The answers will tell you quickly whether you are talking to someone who has built one of these before.